: Plug the field wiring (12 VDC power, cabinet tamper, and AC power fail inputs) into the new board.
The is a high-performance, OnGuard-compatible hardware board designed specifically to retrofit legacy CASI-Rusco M5 and M3000 access control architectures. Acting as a direct, one-for-one, plug-compatible replacement for outdated CASI CPUs (E, P, PX, PXN, and PXNplus) and power/communication boards, it provides a seamless migration path to modern security environments. This comprehensive installation manual covers technical data, mechanical mounting, field wiring, web configuration, and system commissioning. Technical Specifications & Requirements
Intelligent Dual-Reader Controller, a key component within the Lenel OnGuard access control ecosystem. Lenel LNL-3300-M5
By the end of the week, every controller bore a small sticker with the new firmware version and the date. The UPD_TOP manual had a new life: marginalia that turned technical prose into a campus-specific playbook. Mira converted her checklist into a living document in their ticketing system and scheduled staggered firmware checks for the next quarter. lenel lnl3300m5 installation manual upd top
Installation Manual: A Comprehensive Guide to Top-Tier Installation The Lenel LNL-3300-M5
For downstream controllers lacking these inputs (like the LNL-8000-MCOM), integrators must wire these switches to available inputs on an LNL-1100-20DI board or reader port inputs.
Connect the TCP/IP network cable to the RJ-45 port for direct OnGuard communication. : Plug the field wiring (12 VDC power,
Configures database sizing for cardholders, events, and time zones. Consult your OnGuard system design file for specific database allocations. Switch 5 (Cardholder Profile): Sets advanced card formats.
Assign the target static IP address, subnet mask, and default gateway authorized by the network administrator.
: Power up the new controller to begin communication with the OnGuard system. Initial Network Configuration The UPD_TOP manual had a new life: marginalia
PoE+ Switch → RJ45 (LNL-3300-M5) Reader 1 → Terminal Block A (Red=12V, Black=GND, Green=D0, White=D1, Purple=OSDP+, Orange=OSDP-) Reader 2 → Terminal Block B (same) Input 1 → IN1+ / IN1- (with EOL resistor across) Relay 1 → NO1 / C1 / NC1 (lock/door strike)
Form-factor compliant with legacy Software House MR50 enclosures for seamless mechanical drop-in replacement. 📐 Board Layout and Component Identification
Ensure the RS-485 network is configured in a daisy-chain fashion. 5. Network Configuration LNL-3300-M5 communicates with the OnGuard server via Ethernet.
Power down all legacy controllers before removing any wiring. 3. Installation Steps for LNL-3300-M5