Anterwell Technology Ltd.
Large Original stock of IC Electronics Components, Transistors, Diodes etc. Kt 70 Installation Manual
High Quality, Reasonable Price, Fast Delivery. Ensure all ground pins are securely connected to
Ensure all ground pins are securely connected to the airframe ground to reduce electrical noise. 5. Configuration and Post-Installation Checkout
The KT 70 connects to the aircraft harness via a rear-mounted d-sub connector. Clean, secure wiring is paramount for Mode S data integrity. Primary Pinout Functions
Before mounting any hardware, you must verify that the installation complies with civil aviation authorities (such as the FAA or EASA). Airworthiness Requirements
Detailed instructions on securing the mounting tray and sliding the unit into place. System Interconnect:
The KT 70 features an internal cooling fan. However, tightly packed avionics stacks require an external dedicated cooling duct. Connect a 1-inch cooling hose from an avionics blower to the intake port on the rear backplate assembly. 3. Electrical Wiring and Pin Connections
Must meet TSO requirements (minimum 125 watts at the antenna).
High-efficiency, low-loss coaxial cable (such as Electronic Cable Specialists or PIC wire) is mandatory. Post-Installation Alignment and Checkout
This device is used for professional calibration and pressure testing.
The design allows the PCB to be captured securely between the top and bottom halves when closed. 3. Closure and Assembly
11.10 inches (28.19 cm) behind the panel (excluding rear connectors).
Ensure the PCB fits within the internal dimensions of approximately
Some installations utilize serial data for cleaner wiring.
Ensure all ground pins are securely connected to the airframe ground to reduce electrical noise. 5. Configuration and Post-Installation Checkout
The KT 70 connects to the aircraft harness via a rear-mounted d-sub connector. Clean, secure wiring is paramount for Mode S data integrity. Primary Pinout Functions
Before mounting any hardware, you must verify that the installation complies with civil aviation authorities (such as the FAA or EASA). Airworthiness Requirements
Detailed instructions on securing the mounting tray and sliding the unit into place. System Interconnect:
The KT 70 features an internal cooling fan. However, tightly packed avionics stacks require an external dedicated cooling duct. Connect a 1-inch cooling hose from an avionics blower to the intake port on the rear backplate assembly. 3. Electrical Wiring and Pin Connections
Must meet TSO requirements (minimum 125 watts at the antenna).
High-efficiency, low-loss coaxial cable (such as Electronic Cable Specialists or PIC wire) is mandatory. Post-Installation Alignment and Checkout
This device is used for professional calibration and pressure testing.
The design allows the PCB to be captured securely between the top and bottom halves when closed. 3. Closure and Assembly
11.10 inches (28.19 cm) behind the panel (excluding rear connectors).
Ensure the PCB fits within the internal dimensions of approximately
Some installations utilize serial data for cleaner wiring.