The screen will light up, display full segments, and a tower/wave icon will begin flashing. This flashing icon indicates it is actively searching for the atomic time signal. Step 3: Time Zone Selection
Thank you for choosing the Kincaid Radio Controlled Clock. Your clock is equipped with a built-in receiver that synchronizes automatically with the official atomic time signal. This ensures your clock is always accurate to the second, automatically adjusting for Daylight Saving Time (DST) and leap years.
Follow the manual setup instructions to access the time zone settings. Change the zone parameter (e.g., from Pacific to Eastern) to match your physical location. kincaid radio controlled clock instruction manual
If the clock does not find a signal immediately, or if you live in an area with weak reception, you can configure the clock manually. Time Zone Selection
Verify that your Time Zone and DST variables are programmed accurately. 6. Technical Specifications The screen will light up, display full segments,
Arthur squinted. Probably a mistranslation from the nineties.
For most Kincaid analog models, follow these steps to get started: Your clock is equipped with a built-in receiver
Follow these step-by-step instructions to get your Kincaid clock up and running out of the box. Step 1: Battery Installation Open the battery compartment on the back of the clock.
Since Kincaid produces various models (wall clocks, mantel clocks, and grandfather clocks), the instructions below cover the standard Radio Controlled movement used in almost all Kincaid models. These clocks synchronize with the broadcast by NIST from Fort Collins, Colorado.
Press and hold the button for 3–5 seconds until the digital display digits begin to flash (or the setup mode activates).
. Replace the battery with a fresh alkaline one (voltage should be above 1.25V). Wrong Hour