Hw133v10 Datasheet Exclusive |verified| File

: –25°C to +50°C (without freezing) Storage Temperature : –40°C to +70°C Environmental Protection : IP65 front panel sealing rating Terminal Protection : IP20 touch-safe contact rating Mechanical Longevity : High-cycle durable structural design Voltage and Current Ratings

: Dual LEDs are typically present to signal charging status (e.g., Red for charging, Blue/Green for fully charged). Output Pins : Connections for the lithium battery cells. Out+ / Out- : Connections for the load (your project/device). or specific resistor values to change the charging speed? Hw-133-v1.0 Datasheet

Date: October 26, 2023

The HW133V10 operates at a fixed frequency of 1.5 MHz . This high frequency is a deliberate design choice. It allows engineers to utilize smaller inductors and capacitors. hw133v10 datasheet exclusive

Aris felt the hair on his arms rise. Phi. The golden ratio. This wasn't a transducer for moving rock or fluid. It was a device for tuning reality.

As a "Step-Down" module, the output voltage must always be lower than the input voltage (typically at least 1.5V difference for stable operation). Heat Dissipation:

The 6x UARTs and extensive connectivity make it suitable for complex, modular IoT designs. : –25°C to +50°C (without freezing) Storage Temperature

Switch Node Connection. Linked internally to the high-side power MOSFET.

Through-hole axial resistors like the HW133V10 are compatible with wave soldering, hand soldering, and reflow processes. Observe the following guidelines:

Place an array of at least 4 to 6 thermal vias directly beneath the Exposed Pad (EP). Connect these vias to internal or bottom-layer copper planes to maximize heat sinking. 6. Protection Features or specific resistor values to change the charging speed

| Parameter | Symbol | Min | Max | Unit | | :--- | :--- | :--- | :--- | :--- | | Supply Voltage (VBAT) | $V_BAT$ | -0.3 | 6.5 | V | | Input Voltage (Digital Pins) | $V_IO$ | -0.3 | $V_IO + 0.3$ | V | | Operating Temperature | $T_OP$ | -40 | +85 | °C | | Storage Temperature | $T_STG$ | -45 | +90 | °C | | ESD Sensitivity (HBM) | $V_ESD$ | | 1000 (Data), 2000 (Ant) | V |

Enable Input. Pull high to enable the IC; pull below 0.4V to force shutdown mode.