Canon Service Tool V3800 Work Review

The specific function you selected (like changing the region) isn't supported by your firmware.

iP2770, iP2772, iP3600, iP4700, iP4870, iP4970 Pixma MP Series: MP230, MP250, MP280, MP287, MP490, MP495

Right-click on ServiceTool_V3800.exe and select Run as Administrator .

If you reset the EEPROM counter multiple times without addressing the physical pads, the excess ink will eventually overflow past the bottom plastic trays. This can ruin furniture, cause internal electrical shorts, or destroy the printer's main power supply board. Sustainable Options After a Reset canon service tool v3800

Beside , ensure Main is selected in the dropdown menu. Click the Set button located to the right of the dropdown.

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

Released around the mid-2010s, the V3800 was the Holy Grail. It was stable, it was clean, and it supported a massive swath of Canon’s most popular consumer and prosumer printers: the PIXMA G-series (the mega-tank revolution), the MG series, the MX series, and the IP series. The specific function you selected (like changing the

If the tool encounters an issue during use, it may display the following errors: Canon service tool v2000 | Page 11 - PrinterKnowledge

If the light stays solid, your printer is now in Service Mode. If the alarm light stays solid orange, the sequence failed, and you must turn off the printer and try again. Step 2: Running the v3800 Software

If you power off the printer during the EEPROM write process, you can corrupt the firmware. The printer will never turn on again (hard brick). This can ruin furniture, cause internal electrical shorts,

The green power light will flash for a few seconds and then stay solid. Your computer may play a sound indicating new hardware was found (often labeled as "Canon Device" or "Service Mode").

Resets the Main and Platen waste ink absorber counters.