: If the tool still doesn't see the drive, you may need to manually enter "Test Mode" by shorting specific pins on the controller chip (only recommended for advanced users). Change VID/PID : Sometimes changing the ID using the Alcor Change PID/VID Rework utility can help the software recognize the hardware. : Always use a USB 2.0 port
Wait for the user interface to load completely before inserting the broken flash drive. Step 2: Insert the USB Drive and Check Status alcor micro unknown fa00 f w 3613 updated
Press the , type cmd , right-click it, and choose Run as administrator . Type diskpart and hit Enter. : If the tool still doesn't see the
Disclaimer: This process will completely wipe any remaining data on the flash drive. It is a tool for hardware recovery, not data recovery. Step 2: Insert the USB Drive and Check
: The software that manages data flow on the drive has crashed or become corrupted.
Why? Because the is a relatively late firmware revision for this chip family. Most public drivers available on the internet (versions 1.0.6.0, 1.0.19.0, etc.) were written for older firmware like 3510 or 3520. When Windows queries the chip and receives "FA00 F/W 3613," the older driver's INF file does not contain a matching hardware ID. Hence, "Unknown Device."
: For "FA00" errors, you may need a version specifically compatible with "SN-TA" or "SN-GT" controllers. Configure the Driver Open AlcorMP and click the Enter your device's Add VID/PID Save/Install to ensure the tool can "see" the device. Low-Level Format (Production) Plug in the drive. If it's not detected, click Refresh (R)